Research

Paper · MFC

Nitrifying biocathode enables effective electricity generation and sustainable wastewater treatment with microbial fuel cell

01

Summary

What the paper reports, in its own words.

3D Interactive ModelAI Enhanced· 70%

Abstract

Simultaneous organics removal and nitrification using a novel nitrifying biocathode microbial fuel cell (MFC) reactor were investigated in this study. Remarkably, the introduction of nitrifying biomass into the cathode chamber caused higher voltage outputs than that of MFC operated with the abiotic cathode. Results showed the maximum power density increased 18% when cathode was run under the biotic condition and fed by nitrifying medium with alkalinity/NH4+-N ratio of 8 (26 against 22 mW/m²). The voltage output was not differentiated when NH4+-N concentration was increased from 50 to 100 mg/L under such alkalinity/NH4+-N ratio. However, interestingly, the cell voltage rose significantly when the alkalinity/NH4+-N ratio was decreased to 6. Consequently, the maximum power density increased 68% in compared with the abiotic cathode MFC (37 against 22 mW/m²). Polarization curves demonstrated that both activation and concentration losses were lowered during the period of nitrifying biocathode operation. Ammonium was totally nitrified and mostly converted to nitrate in all cases of the biotic cathode conditions. High COD removal efficiency (98%) was achieved. In light of the results presented here, the application of nitrifying biocathode is not only able to integrate the nitrogen and carbon removal but also to enhance the power generation in MFC system. Our system can be suggested to open up a new feasible way for upgrading and retrofitting the existing wastewater treatment plant by the use of MFC-based technologies.

AI summary: matches the abstract (70% confidence) · review against source PDF

02

Extracted values

Every value pulled from the paper, with its source, so each number can be checked against the text.

n = 5 extracted values

Select a citation to see the quote, page and confidence behind a value.

0 of 3 extracted rows modelable

  • 3 no SI value
ParameterValueUnitConfidenceSourceModelable
Substratewastewater—80%
llm
Maximum power density22mW/m²80%
llm
Inoculum sourcewastewater treatment plant—80%
extracted
Excluded: no SI value
Cathode materialbiocathode—60%
extracted
Excluded: no SI value
Cathode materialnitrifying biocathode—50%
extracted
Excluded: no SI value

Methodology

What was the system and how was it run

Methodology

Methodology

The study investigated the performance of a nitrifying biocathode MFC reactor using a novel nitrifying biomass.

System configuration

FieldValue
system typeMFC

Biological parameters

FieldValue
inoculum sourcewastewater treatment plant

Performance metrics

FieldValue
max power density22
citation count11

Operational parameters

FieldValue
substrate["wastewater"]

Electrochemical data

FieldValue
max power density22

Pipeline

Raw extractions, artifacts, quality signal

Extraction quality

honesty signal

Calibrate your trust in the extracted content against these signals — they're how the pipeline rated its own output for this paper.

Parameter completeness

75%

Fraction of expected parameters extracted

Reproducibility

41%

How reproducible the setup is from this paper alone

Data completeness

80%

Overall extraction coverage across fields

AI confidence

70%

Model self-reported confidence

Mean parameter confidence

70%

Average confidence across PaperParameter rows surfaced above

review against source PDF before citing · scores 0–1

03

Chart explorer

Move the inputs this paper used and see how the predicted outcome shifts.

04

Explore model

The reactor in 3D, with flow you can switch on and off.

05

AI insights

Contradictions, gaps and opportunities found by comparing this paper with the corpus.

06

Compare similar papers

The nearest papers by system, materials and organisms, with their outcomes side by side.

loading 3D model…

Representative model, generic MFC

Representative MFC — matched on the paper’s system type only, not its reactor or geometry.

MFC
System
37.0milliwatts per square metre
Best result · Power density
best of 3
5
Extracted values
2009
Year

Keywords

  • Alkalinity
  • Microbial fuel cell
  • Nitrification
  • Nitrate
  • Nitrifying bacteria
  • Ammonium

Cite

Hung-Thuan Tran, Dae-Hee Kim, Se-Jin Oh et al. (2009). Nitrifying biocathode enables effective electricity generation and sustainable wastewater treatment with microbial fuel cell. Water Science and Technology. https://doi.org/10.2166/wst.2009.209

Open in lab for full controls, parameter editing, and template overlays.

Open in lab