Research

Paper

The Influence of Alkali Cations on the Performance of Pt Electrodes in Kolbe Electrolysis of Acetic Acid

01

Summary

What the paper reports, in its own words.

ElectrosynthesisBiomass Valorization

Abstract

Electrochemical decarboxylation of carboxylic acids is considered a sustainable method to improve the quality of pyrolysis oil. In this study, we assess the effect of monovalent alkali cations (of the acetates) on the performance of Pt electrodes in acid decarboxylation and the competing OER, using various electrochemical methods. We reveal a strong cation dependence generally following the trend Li⁺<Na⁺<K⁺~Cs⁺ within a large pH range. Using rotating ring disc electrode measurements, we highlight the strong contribution of the oxygen evolution reaction particularly for electrolytes containing Li⁺ and Na⁺ which decreases the selectivity for Kolbe oxidation. In addition, the faradaic efficiency (FE) towards methanol ranges between 16 % (for Li⁺) and 29 % (for Cs⁺) at high solution pH (9 or 12). The observed trends are generally explained by a cation‐dependent interfacial pH and surface coverage of acetate, both lowest for Li. This is evident from differences in charge transfer resistance determined by impedance measurements and local pH measurements. Additionally, enhanced dissolution of Pt by Li⁺ is also proposed. This work highlights that K⁺ and Cs⁺ cations favor FE for electrochemical Kolbe oxidation, at relatively low current densities.

02

Extracted values

Every value pulled from the paper, with its source, so each number can be checked against the text.

n = 34 extracted values

Select a citation to see the quote, page and confidence behind a value.

0 of 34 extracted rows modelable

  • 34 not canonicalised (no canonical slug)
ParameterValueUnitConfidenceSourceNotesModelable
Low current density, limitation of cation effects10mA/cm²100%
extracted
"At low current density (10 mA/cm2), the concentration of methyl radicals at the …" · acids=["acetic acid"], electrode=Pt, electrolyte=1 M acetic acid/AM+-acetateExcluded: not canonicalised (no canonical slug)
RRDE rotation rate1,500rpm100%
rotating ring-disk electrode (rrde)
"(b) CV scans from 0.5- 3 VRHE of 1 M acetic acid/AM + -acetate (pH 5) at 1500 rp…" · ph=5, acids=["acetic acid"], electrode=Pt, electrolyte=1 M acetic acid/AM+-acetateExcluded: not canonicalised (no canonical slug)
Scan rate of cyclic voltammetry100mV/s100%
extracted
"CVs were obtained at a scan speed of 100 mV/s in the potential range from 0-3 VR…" · acids=["acetic acid"], electrode=Pt, electrolyte=1 M acetic acid/AM+-acetateExcluded: not canonicalised (no canonical slug)
Electrolyte pH range investigated3—100%
extracted
"across a wide range of (bulk) electrolyte pH (3-12) and applied current densitie…" · acids=["acetic acid"], electrode=Pt, electrolyte=1 M acetic acid/AM+-acetateExcluded: not canonicalised (no canonical slug)
Distance of pH sensor from Pt electrode surface1.8mm100%
extracted
"side opening placed near the Pt electrode surface (1.8 mm distance)" · electrode=Pt foil, electrolyte=1 M acetic acid/AM+-acetate, bulk pH 5, current_density=25 mA/cm2Excluded: not canonicalised (no canonical slug)
Potential at which PEIS was performed2.1VRHE100%
potentiostatic eis (peis)
"the electrode is polarized at 2.1 VRHE" · ph=5, acids=["acetic acid"], electrode=Pt, electrolyte=1 M acetic acid/AM+-acetateExcluded: not canonicalised (no canonical slug)
Potential window of cyclic voltammetry0VRHE100%
extracted
"CVs were obtained at a scan speed of 100 mV/s in the potential range from 0-3 VR…" · acids=["acetic acid"], electrode=Pt, electrolyte=1 M acetic acid/AM+-acetateExcluded: not canonicalised (no canonical slug)
Bulk electrolyte pH values for cyclic voltammetry3—100%
extracted
"The electrolyte pH was adjusted to (a) pH 3 (b) pH 5 (c) pH 9 and (d) pH 12, res…" · acids=["acetic acid"], electrode=Pt, electrolyte=1 M acetic acid/AM+-acetateExcluded: not canonicalised (no canonical slug)
Current density range investigated10mA/cm²100%
extracted
"across a wide range of (bulk) electrolyte pH (3-12) and applied current densitie…" · acids=["acetic acid"], electrode=Pt, electrolyte=1 M acetic acid/AM+-acetateExcluded: not canonicalised (no canonical slug)
Total acetic acid/acetate electrolyte concentration1M95%
extracted
"(b) CV scans from 0.5- 3 VRHE of 1 M acetic acid/AM + -acetate (pH 5) at 1500 rp…" · ph=5, acids=["acetic acid"], electrode=Pt, electrolyte=1 M acetic acid/AM+-acetateExcluded: not canonicalised (no canonical slug)
Current density in chronopotentiometric product measurements25mA/cm²95%
extracted
"Measurements were performed at 25 mA/cm2 to enable reproducible product detectio…" · cell=undivided batch cell, no membrane, acids=["acetic acid"], electrode=Pt, electrolyte=1 M acetic acid/AM+-acetateExcluded: not canonicalised (no canonical slug)
Lower acetate electrolyte concentration tested0.63M90%
extracted
"concentration-dependent measurements performed with 0.63 M AM + acetate and 1 M …" · electrode=PtExcluded: not canonicalised (no canonical slug)
Near-surface (local) pH during Kolbe electrolysis, Na+ acetate4.2—90%
ph meter with side-opening tip near the pt surface
"A decrease in pH was observed for all cations used with the extent of pH decreas…" · ph=5 (bulk), cation=Na+, electrode=Pt foil, electrolyte=1 M acetic acid/AM+-acetate, bulk pH 5Excluded: not canonicalised (no canonical slug)
Peak potential showing transition from OER to Kolbe reaction (Cs+ acetate, low scan rate)2.5VRHE90%
rrde / cyclic voltammetry
"The peak at 2.5-2.6 VRHE shows the transition of the OER to the Kolbe reaction a…" · ph=5, acids=["acetic acid"], cation=Cs+, electrode=PtExcluded: not canonicalised (no canonical slug)
Potential of inflection zone (OER to Kolbe transition), pH 122.3VRHE90%
cyclic voltammetry
"In the inflection zone (at ~2.5 VRHE at pH 9 and at ~2.3 VRHE at pH 12)" · ph=12, acids=["acetic acid"], electrode=Pt, electrolyte=1 M acetic acid/AM+-acetateExcluded: not canonicalised (no canonical slug)
Potential of inflection zone (OER to Kolbe transition), pH 92.5VRHE90%
cyclic voltammetry
"In the inflection zone (at ~2.5 VRHE at pH 9 and at ~2.3 VRHE at pH 12)" · ph=9, acids=["acetic acid"], electrode=Pt, electrolyte=1 M acetic acid/AM+-acetateExcluded: not canonicalised (no canonical slug)
Potential at which selectivity changes from OER to Kolbe (RRDE)2.5VRHE90%
rotating ring-disk electrode (rrde)
"The selectivity changes from OER to Kolbe at approx. 2.5 VRHE" · ph=5, acids=["acetic acid"], electrode=Pt, electrolyte=1 M acetic acid/AM+-acetateExcluded: not canonicalised (no canonical slug)
Current onset potential (not affected by monovalent cations)1.8VRHE90%
cyclic voltammetry
"the current onset potential (~1.8 VRHE) is not affected by monovalent" · ph=5, acids=["acetic acid"], cation=Li+, Na+, K+, Cs+, electrode=PtExcluded: not canonicalised (no canonical slug)
Faradaic efficiency towards methanol, Li+ acetate16%90%
inline gc
"the faradaic efficiency (FE) towards methanol ranges between 16 % (for Li +) and…" · ph=9 or 12, acids=["acetic acid"], cation=Li+, electrode=PtExcluded: not canonicalised (no canonical slug)
Averaged faradaic efficiency towards ethane at pH 5 (minimum across all cations)82%90%
inline gc
"Indeed at pH 5, a high averaged faradaic efficiency (above 82 %) towards the cou…" · ph=5, acids=["acetic acid"], cation=Li+, Na+, K+, Cs+, electrode=PtExcluded: not canonicalised (no canonical slug)
Faradaic efficiency towards methanol, Cs+ acetate29%90%
inline gc
"the faradaic efficiency (FE) towards methanol ranges between 16 % (for Li +) and…" · ph=9 or 12, acids=["acetic acid"], cation=Cs+, electrode=PtExcluded: not canonicalised (no canonical slug)
Average faradaic efficiency for oxygen evolution (OER) at pH 3 (range across Li+, Na+, K+, Cs+)70%90%
inline gc
"with FE values ranging from 70-89 %" · ph=3, acids=["acetic acid"], cation=Li+, Na+, K+, Cs+, electrode=PtExcluded: not canonicalised (no canonical slug)
Near-surface (local) pH during Kolbe electrolysis, K+ acetate4.4—90%
ph meter with side-opening tip near the pt surface
"A decrease in pH was observed for all cations used with the extent of pH decreas…" · ph=5 (bulk), cation=K+, electrode=Pt foil, electrolyte=1 M acetic acid/AM+-acetate, bulk pH 5Excluded: not canonicalised (no canonical slug)
Near-surface (local) pH during Kolbe electrolysis, Li+ acetate3.1—90%
ph meter with side-opening tip near the pt surface
"A decrease in pH was observed for all cations used with the extent of pH decreas…" · ph=5 (bulk), cation=Li+, electrode=Pt foil, electrolyte=1 M acetic acid/AM+-acetate, bulk pH 5Excluded: not canonicalised (no canonical slug)
Near-surface (local) pH during Kolbe electrolysis, Cs+ acetate4.5—90%
ph meter with side-opening tip near the pt surface
"A decrease in pH was observed for all cations used with the extent of pH decreas…" · ph=5 (bulk), cation=Cs+, electrode=Pt foil, electrolyte=1 M acetic acid/AM+-acetate, bulk pH 5Excluded: not canonicalised (no canonical slug)
Showing 25 of 34

Pipeline

Raw extractions, artifacts, quality signal

Extraction quality

honesty signal

Calibrate your trust in the extracted content against these signals — they're how the pipeline rated its own output for this paper.

Mean parameter confidence

88%

Average confidence across PaperParameter rows surfaced above

review against source PDF before citing · scores 0–1

03

Chart explorer

Move the inputs this paper used and see how the predicted outcome shifts.

04

Explore model

The reactor in 3D, with flow you can switch on and off.

05

AI insights

Contradictions, gaps and opportunities found by comparing this paper with the corpus.

06

Compare similar papers

The nearest papers by system, materials and organisms, with their outcomes side by side.

07

Source PDF

The paper as published.

No 3D model is mapped to this paper yet. The values extracted from it are listed under Extracted values.

34
Extracted values
2024
Year

Keywords

  • acetic acid
  • alkali metal cations
  • platinum electrode
  • Kolbe electrolysis
  • electrochemical decarboxylation
  • bio-oil upgrading
  • Faradaic efficiency
  • interfacial pH

Cite

Talal Ashraf, Bastian Timo Mei, Guido Mul (2024). The Influence of Alkali Cations on the Performance of Pt Electrodes in Kolbe Electrolysis of Acetic Acid. ChemElectroChem. https://doi.org/10.1002/celc.202400274