Paper
Determining incremental coulombic efficiency and physiological parameters of early stage Geobacter spp. enrichment biofilms
- Dual Chamber
- Single Chamber
- Bioanode Only
- Mixed Culture
- Anode: Bioanode
- Membrane: CEM Generic
Summary
What the paper reports, in its own words.
Abstract
Geobacter spp. enrichment biofilms were cultivated in batch using one-chamber and two-chamber bioelectrochemical reactors. Time-resolved substrate quantification was performed to derive physiological parameters as well as incremental coulombic efficiency (i.e., coulombic efficiency during one batch cycle, here every 6h) during early stage biofilm development. The results of one-chamber reactors revealed an intermediate acetate increase putatively due to the presence of acetogens. Total coulombic efficiencies of two-chamber reactors were considerable lower (19.6±8.3% and 49.3±13.2% for 1st and 2nd batch cycle, respectively) compared to usually reported values of mature Geobacter spp. enrichment biofilms presumably reflecting energetic requirements for biomass production (i.e., cells and extracellular polymeric substances) during early stages of biofilm development. The incremental coulombic efficiency exhibits considerable changes during batch cycles indicating shifts between phases of maximizing metabolic rates and maximizing biomass yield. Analysis based on Michaelis-Menten kinetics yielded maximum substrate uptake rates (vmax,Ac, vmax,I) and half-saturation concentration coefficients (KM,Ac,KM,I) based on acetate uptake or current production, respectively. The latter is usually reported in literature but neglects energy demands for biofilm growth and maintenance as well as acetate and electron storage. From 1st to 2nd batch cycle, vmax,Ac and KM,Ac, decreased from 0.0042-0.0051 mmol Ac- h-1 cm-2 to 0.0031-0.0037 mmol Ac- h-1 cm-2 and 1.02-2.61 mM Ac- to 0.28-0.42 mM Ac-, respectively. Furthermore, differences between KM,Ac/KM,I and vmax,Ac/vmax,I were observed providing insights into the physiology of Geobacter spp. enrichment biofilms. Notably, KM,I considerably scattered while vmax,Ac/vmax,I and KM,Ac remained rather stable indicating that acetate transport within biofilm only marginally affects reaction rates. The observed data variation mandates the requirement of a more detailed analysis with an improved experimental system, e.g., using flow conditions and a comparison with Geobacter spp. pure cultures.
Extracted values
Every value pulled from the paper, with its source, so each number can be checked against the text.
n = 11 extracted values
Select a citation to see the quote, page and confidence behind a value.
0 of 8 extracted rows modelable
- 8 not canonicalised (no canonical slug)
| Parameter | Value | Unit | Confidence | Source | Notes | Modelable |
|---|---|---|---|---|---|---|
| Substrate | — | — | 100% | llm | results | |
| Coulombic efficiency | 19.6 | % | 90% | llm | results | |
| Electrode Surface Area | 10 | cm² | 90% | llm | results | |
| Microbial kinetic constants vmax | 0.0042 | mmol Ac⁻ h⁻¹ cm⁻² | 90% | extracted | "vmax,Ac and KM,Ac, decreased from 0.0042–0.0051 mmol Ac−h−1 cm−2 to 0.0031–0.003…" · substrate=acetate, batch | Excluded: not canonicalised (no canonical slug) |
| Microbial kinetic constants vmax | 0.0051 | mmol Ac⁻ h⁻¹ cm⁻² | 90% | extracted | "vmax,Ac and KM,Ac, decreased from 0.0042–0.0051 mmol Ac−h−1 cm−2 to 0.0031–0.003…" · substrate=acetate, batch | Excluded: not canonicalised (no canonical slug) |
| Microbial kinetic constants vmax | 0.0031 | mmol Ac⁻ h⁻¹ cm⁻² | 90% | extracted | "vmax,Ac and KM,Ac, decreased from 0.0042–0.0051 mmol Ac−h−1 cm−2 to 0.0031–0.003…" · substrate=acetate, batch | Excluded: not canonicalised (no canonical slug) |
| Microbial kinetic constants km | 0.28 | mM Ac⁻ | 90% | extracted | "KM,Ac, decreased from 1.02–2.61 mM Ac− to 0.28–0.42 mM Ac−" · substrate=acetate, batch | Excluded: not canonicalised (no canonical slug) |
| Microbial kinetic constants km | 0.42 | mM Ac⁻ | 90% | extracted | "KM,Ac, decreased from 1.02–2.61 mM Ac− to 0.28–0.42 mM Ac−" · substrate=acetate, batch | Excluded: not canonicalised (no canonical slug) |
| Microbial kinetic constants km | 2.61 | mM Ac⁻ | 90% | extracted | "KM,Ac, decreased from 1.02–2.61 mM Ac− to 0.28–0.42 mM Ac−" · substrate=acetate, batch | Excluded: not canonicalised (no canonical slug) |
| Microbial kinetic constants vmax | 0.0037 | mmol Ac⁻ h⁻¹ cm⁻² | 90% | extracted | "vmax,Ac and KM,Ac, decreased from 0.0042–0.0051 mmol Ac−h−1 cm−2 to 0.0031–0.003…" · substrate=acetate, batch | Excluded: not canonicalised (no canonical slug) |
| Microbial kinetic constants km | 1.02 | mM Ac⁻ | 90% | extracted | "KM,Ac, decreased from 1.02–2.61 mM Ac− to 0.28–0.42 mM Ac−" · substrate=acetate, batch | Excluded: not canonicalised (no canonical slug) |
Methodology
What was the system and how was it run
Operating conditions
9 runs extracted| Run | T°C | pHan | pHcat | Substrate | [S]mg/L | HRTh | Mode | R_extΩ | V_appV | Inoculum |
|---|---|---|---|---|---|---|---|---|---|---|
| baseline_1chamber | — | — | — | acetate | — | — | batch | — | — | — |
| baseline_1chamber #2 | — | — | — | acetate | — | — | batch | — | — | — |
| baseline_1chamber #3 | — | — | — | acetate | — | — | batch | — | — | — |
| baseline_2chamber | — | — | — | acetate | — | — | batch | — | — | — |
| baseline_2chamber #2 | — | — | — | acetate | — | — | batch | — | — | — |
| baseline_2chamber #3 | — | — | — | acetate | — | — | batch | — | — | — |
| curve_extractor_v3 | 35 | — | — | acetate | 590.4 | — | — | — | 0.397 | — |
| curve_extractor_v3 #2 | 35 | — | — | acetate | 590.4 | — | — | — | 0.397 | — |
| v2-584ec2cc05e3c236 | — | — | — | acetate | — | — | batch | — | — | — |
Microbial kinetics
37 constants| Organism | Substrate | Parameter | Value | Unit | Conf. |
|---|---|---|---|---|---|
| Geobacter spp. enrichment biofilm | acetate | K_M | 0.35 | millimolar | 93% |
| Geobacter spp. enrichment biofilm | acetate | K_M | 0.35 | millimolar | 93% |
| Geobacter spp. enrichment biofilm | acetate | vmax | 0.0034 | millimoles per hour per square centimetre | 92% |
| Geobacter spp. enrichment biofilm | acetate | vmax | 0.0034 | millimoles per hour per square centimetre | 92% |
| Geobacter spp. | acetate | K_M | 0.28 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 1.02 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 2.61 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 0.28 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 0.42 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 1.02 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 2.61 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 0.42 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 1.02 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 2.61 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 0.28 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 0.42 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 1.02 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 2.61 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 0.28 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | K_M | 0.42 | mM Ac⁻ | 90% |
| Geobacter spp. | acetate | vmax | 0.0042 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0051 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0037 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0031 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0037 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0051 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0031 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0031 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0051 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0042 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0051 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0031 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0037 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0037 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0042 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. | acetate | vmax | 0.0042 | mmol Ac⁻ h⁻¹ cm⁻² | 90% |
| Geobacter spp. enrichment biofilms | acetate | Km | 1.02 | mM Ac⁻ | 85% |
Pipeline
Raw extractions, artifacts, quality signal
Extraction quality
honesty signalCalibrate your trust in the extracted content against these signals — they're how the pipeline rated its own output for this paper.
AI confidence
60%
Model self-reported confidence
Mean parameter confidence
91%
Average confidence across PaperParameter rows surfaced above
review against source PDF before citing · scores 0–1
Chart explorer
Move the inputs this paper used and see how the predicted outcome shifts.
Explore model
The reactor in 3D, with flow you can switch on and off.
AI insights
Contradictions, gaps and opportunities found by comparing this paper with the corpus.
Compare similar papers
The nearest papers by system, materials and organisms, with their outcomes side by side.
Source PDF
The paper as published.
No 3D model is mapped to this paper yet. The values extracted from it are listed under Extracted values.
In this record
Organisms, parameters and materials this paper reports. Each links to its page.
Materials · 2
Keywords
- Faraday efficiency
- Geobacter
- Biofilm
- Substrate (aquarium)
- Saturation (graph theory)
- Biomass (ecology)
Cite
Benjamin Korth, Jörg Kretzschmar, Manuel Bartz et al. (2020). Determining incremental coulombic efficiency and physiological parameters of early stage Geobacter spp. enrichment biofilms. PLoS ONE. https://doi.org/10.1371/journal.pone.0234077