Generic MFCRepresentative model
Click to animate flow
loading 3D model…

Representative MFC — matched on the paper’s system type only, not its reactor or geometry.

Extraction

Reported parameters

No values extracted from this paper yet.

Open in lab for full controls, parameter editing, and template overlays.

Open in lab →

What they did

System
MFC

What worked

No outcome metrics extracted yet.

Abstract

This study evaluated the feasibility of using effluent from the anodic chamber of a microbial fuel cell (MFC), powered by real fruit and vegetable wastewater, as a cultivation medium for Tetraselmis subcordiformis, a microalga capable of bio-photolytic hydrogen production. In three experimental variants, different organic loading rates were applied in the anodic chamber, resulting in significant differences in effluent quality and its suitability as a culture medium. In contrast to the dominant MFC configurations, in which microalgae act as cathodic biocatalysts, the microbial fuel cell in this study was used as a source of the inevitable anode effluent, which was subsequently valorized as a cultivation medium for the marine microalga T. subcordiformis to support biomass and hydrogen production. In variants with moderate COD concentration and low lipid content, the highest biomass concentrations, ranging from 941 ± 104 mg VS/L to 1020 ± 108 mg VS/L, were obtained, along with the highest nitrogen assimilation efficiency (48.7–49.1%) and phosphorus assimilation efficiency (62.3–63.1%). The variant in which the culture medium contained the highest concentrations of COD, TSS, and lipids showed a substantial limitation of biomass growth to 745 ± 75 mg VS/L and lower nutrient removal efficiency (total nitrogen—42.3 ± 4.7%, total phosphorus—55.0 ± 5.0%). The obtained biomass was then used for H2 production in a mineral photobiolytic medium. The highest total hydrogen production reached 184.7 ± 25.0 mL, while the specific hydrogen yield reached 193.7 ± 32.6 mL/g VS. Increased concentration of organic matter in the medium reduced total hydrogen production to 112.0 ± 14.8 mL, mainly due to lower biomass concentration, although the specific hydrogen yield remained high (153.4 ± 25.8 mL/g VS). The biogas composition was stable (H2 58.0–58.7%, CO2 35.3–35.9%, O2 6.0–6.2%).

Keywords

EffluentPulp and paper industryBiomass (ecology)Microbial fuel cellNutrientBiofuel

Identifiers

Journal
Energies
Year
2026