MESSAI.iO

AI summary

70% confidence

Researchers developed low-cost proton exchange membranes (PEMs) using polyvinyl chloride (PVC) for microbial fuel cells (MFCs), achieving higher conductivity and improved performance.

Generated by MESSAI extraction pipeline · review against source PDF

Generic MFCRepresentative model
Click to animate flow
loading 3D model…

Representative MFC — matched on the paper’s system type only, not its reactor or geometry.

Extraction

Reported parameters

50 extracted values

View extracted values

Open in lab for full controls, parameter editing, and template overlays.

Open in lab →

What they did

System
MFC
Substrate
pure compound

What worked

No outcome metrics extracted yet.

Abstract

Abstract Proton exchange membranes (PEMs), used as separators, are one of the important components in microbial fuel cells (MFCs). The efficiency of MFC is greatly influenced by PEM. Nafion, which is a commonly used membrane, has several disadvantages in addition to its high cost. The aim of the present work was to develop low-cost PEMs with higher conductivity. In the current work, membranes were prepared using comparatively cheaper material polyvinyl chloride with different concentrations of silica (SiO 2 ), citric acid and phosphotungstic acid (PWA) by the solution casting method. Different membrane properties such as surface morphology, water uptake capacity, ion exchange capacity (IEC), tensile strength, leaching test and potential applications in MFCs were investigated. The results showed that the prepared membrane with 10% silica has the highest water uptake of 55.8%. The IEC of prepared membranes was found to vary from 0.024 to 0.875 meq/g. The membranes showing better IEC were applied to the MFC. The maximum power density obtained was 43.91 m W/cm 2 in the case of a membrane with both 5% PWA and 5% silica. The results obtained make this membrane a promising and economically viable new material in MFC applications.

Key findings

  • Membranes with 10% silica showed highest water uptake of 55.8%
  • Ion exchange capacity (IEC) of prepared membranes varied from 0.024 to 0.875 meq/g
  • Maximum power density obtained was 43.91 mW/cm² with membranes containing 5% PWA and 5% silica

Keywords

MembraneMicrobial fuel cellPolyvinyl chloridePhosphotungstic acidChemical engineeringProton exchange membrane fuel cell

Identifiers

DOI
10.1515/polyeng-2018-0276
Journal
Journal of Polymer Engineering
Year
2019