AI summary

70% confidence

A membrane-less double-chambered microbial fuel cell was used to simultaneously generate electricity and remove organics from a synthetic solution using municipal wastewater-based microbes.

Generated by MESSAI extraction pipeline · review against source PDF

Generic MFCRepresentative model
Click to animate flow
loading 3D model…

Representative MFC — matched on the paper’s system type only, not its reactor or geometry.

Extraction

Reported parameters

6 extracted values

View extracted values

Open in lab for full controls, parameter editing, and template overlays.

Open in lab →

What they did

System
MFC

What worked

No outcome metrics extracted yet.

Abstract

Abstract In this study, membrane less double chambered microbial fuel cell has been used for the simultaneous electricity generation and organics removal from glucose and glutamic acid (mole ratio 1:1) based synthetic solution in the presence of municipal wastewater activated sludge-based microbes using graphite as an electrode. A central composite design technique has been employed to optimize the experimental conditions using design expert software for modeling input–output model as surface function of various input parameters like initial COD, anodic pH, and run time for voltage and current density generation. The predicted model suggests that maximum voltage and current density generation of ∼14.8 mV and ∼41.11 μA/m 2 , respectively are obtained at COD: 1500 mg/L, pH: 7, run time: 7 days. Further, methylene blue is used as mediator for voltage and current density production at optimum condition. Experimental result depicts the substantial role of mediator concentration and showing maximum current and voltage production, approximately 10 times higher than that without meditator under similar conditions. In addition to bioenergy production, values of BOD and COD in the wastewater simulant are found to be reduced after each run which exists below the permissible limits. The developed model equations give better prediction on the voltage and current density generation which lies within the error limits of −12 to +12% and −2 to 14%, respectively to their corresponding experimental values. Overall, the process can generate simultaneously bioenergy along with wastewater treatment and the empirical model gives better prediction with experimental values.

Key findings

  • Maximum voltage and current density generation of 14.8 mV and 41.11 μA/m², respectively, were obtained at COD: 1500 mg/L, pH: 7, and run time: 7 days.
  • The use of methylene blue as a mediator increased voltage and current density production by approximately 10 times compared to without mediator.
  • The microbial fuel cell showed substantial removal of organics from the synthetic solution.

Keywords

Microbial fuel cellBioenergyWastewaterVoltageCentral composite designCurrent density

Identifiers

Journal
International Journal of Chemical Reactor Engineering
Year
2021