Forschungsdaten – Titel und Zusammenfassungen von Publikationen, extrahierte Daten und Katalogeinträge – erscheinen in ihrer Originalsprache Englisch.

Forschung

Publikation · MES

Selective Enrichment Establishes a Stable Performing Community for Microbial Electrosynthesis of Acetate from CO₂

01

Zusammenfassung

Was die Publikation berichtet, in ihren eigenen Worten.

Interaktives 3D-Modell

Zusammenfassung

The advent of renewable energy conversion systems exacerbates the existing issue of intermittent excess power. Microbial electrosynthesis can use this power to capture CO2 and produce multicarbon compounds as a form of energy storage. As catalysts, microbial populations can be used, provided side reactions such as methanogenesis are avoided. Here a simple but effective approach is presented based on enrichment of a robust microbial community via several culture transfers with H2:CO2 conditions. This culture produced acetate at a concentration of 1.29 ± 0.15 g L⁻¹ (maximum up to 1.5 g L⁻¹; 25 mM) from CO2 at a fixed current of -5 Am⁻² in fed-batch bioelectrochemical reactors at high N2:CO2 flow rates. Continuous supply of reducing equivalents enabled acetate production at a rate of 19 ± 2 gm⁻²d⁻¹ (projected cathode area) in several independent experiments. This is a considerably high rate compared with other unmodified carbon-based cathodes. 58 ± 5% of the electrons was recovered in acetate, whereas 30 ± 10% of the electrons was recovered in H2 as a secondary product. The bioproduction was most likely H2 based; however, electrochemical, confocal microscopy, and community analyses of the cathodes suggested the possible involvement of the cathodic biofilm. Together, the enrichment approach and galvanostatic operation enabled instant start-up of the electrosynthesis process and reproducible acetate production profiles.

02

Extrahierte Werte

Jeder aus der Publikation entnommene Wert mit seiner Quelle, damit sich jede Zahl am Text prüfen lässt.

n = 19 extrahierte Werte

Wählen Sie eine Quellenangabe, um Zitat, Seite und Konfidenz hinter einem Wert zu sehen.

9 von 19 extrahierten Zeilen modellierbar

  • 4 nicht kanonisiert (kein kanonischer Slug)
  • 6 kein SI-Wert
ParameterWertEinheitKonfidenzQuelleAnmerkungenModellierbar
Acetate Production Rate20g m⁻² d⁻¹90 %
extrahiert
"Figure S-9. Acetate production rates achieved with reactors R1 to R6. R1 shows a…" · T=30°C, pH(an)=7.57, substrate=CO2Ausgeschlossen: kein SI-Wert
Electron recovery in H₂20%90 %
extrahiert
"Figure S-7. Influence of gas flow rates on the electron recoveries in acetate an…" · T=30°C, pH(an)=7.57, substrate=CO2Ausgeschlossen: nicht kanonisiert (kein kanonischer Slug)
Acetate Production Rate12g m⁻² d⁻¹90 %
extrahiert
"Figure S-9. Acetate production rates achieved with reactors R1 to R6. R5 shows a…" · T=30°C, pH(an)=8, substrate=CO2Ausgeschlossen: kein SI-Wert
Electron recovery in acetate60%90 %
extrahiert
"Figure S-7. Influence of gas flow rates on the electron recoveries in acetate an…" · T=30°C, pH(an)=7.57, substrate=CO2Ausgeschlossen: nicht kanonisiert (kein kanonischer Slug)
Acetate Production Rate14g m⁻² d⁻¹90 %
extrahiert
"Figure S-9. Acetate production rates achieved with reactors R1 to R6. R6 shows a…" · T=30°C, pH(an)=8, substrate=CO2Ausgeschlossen: kein SI-Wert
Acetate Production Rate18g m⁻² d⁻¹90 %
extrahiert
"Figure S-9. Acetate production rates achieved with reactors R1 to R6. R3 shows a…" · T=30°C, pH(an)=7.69, substrate=CO2Ausgeschlossen: kein SI-Wert
Acetate Production Rate16g m⁻² d⁻¹90 %
extrahiert
"Figure S-9. Acetate production rates achieved with reactors R1 to R6. R4 shows a…" · T=30°C, pH(an)=7.69, substrate=CO2Ausgeschlossen: kein SI-Wert
Acetic Acid Concentration50mg/L90 %
extrahiert
"Figure S-6. Microbial electrosynthesis with reactor R2 with a prolonged batch cy…" · T=30°C, pH(an)=7.5, substrate=CO2Modellierbar
Acetate Production Rate22g m⁻² d⁻¹90 %
extrahiert
"Figure S-9. Acetate production rates achieved with reactors R1 to R6. R2 shows a…" · T=30°C, pH(an)=7.5, substrate=CO2Ausgeschlossen: kein SI-Wert
Electron recovery in acetate65%90 %
extrahiert
"Figure S-7. Influence of gas flow rates on the electron recoveries in acetate an…" · T=30°C, pH(an)=7.5, substrate=CO2Ausgeschlossen: nicht kanonisiert (kein kanonischer Slug)
Electron recovery in H₂15%90 %
extrahiert
"Figure S-7. Influence of gas flow rates on the electron recoveries in acetate an…" · T=30°C, pH(an)=7.5, substrate=CO2Ausgeschlossen: nicht kanonisiert (kein kanonischer Slug)
Acetic Acid Concentration1.850mg/L90 %
extrahiert
"Table S-3. VFAs produced by the representative enriched mixed microbial culture …" · T=30°C, substrate=CO2:H2Modellierbar
Acetic Acid Concentration587mg/L90 %
extrahiert
"Table S-3. VFAs produced by the representative enriched mixed microbial culture …" · T=30°C, substrate=CO2:H2Modellierbar
Acetic Acid Concentration1.200mg/L90 %
extrahiert
"Figure S-4. Production of volatile fatty acids (VFAs) in reactors R1 and R2 oper…" · T=30°C, pH(an)=7.57, substrate=CO2Modellierbar
Acetic Acid Concentration1.800mg/L90 %
extrahiert
"Figure S-8. Acetate production and bicarbonate concentration profiles for reacto…" · T=30°C, pH(an)=8, substrate=CO2Modellierbar
Acetic Acid Concentration1.500mg/L90 %
extrahiert
"Figure S-8. Acetate production and bicarbonate concentration profiles for reacto…" · T=30°C, pH(an)=8, substrate=CO2Modellierbar
Propionic Acid Concentration160mg/L90 %
extrahiert
"Table S-3. VFAs produced by the representative enriched mixed microbial culture …" · T=30°C, substrate=CO2:H2Modellierbar
Butyrate Concentration743mg/L90 %
extrahiert
"Table S-3. VFAs produced by the representative enriched mixed microbial culture …" · T=30°C, substrate=CO2:H2Modellierbar
Acetic Acid Concentration1.500mg/L90 %
extrahiert
"Figure S-4. Production of volatile fatty acids (VFAs) in reactors R1 and R2 oper…" · T=30°C, pH(an)=7.5, substrate=CO2Modellierbar

Methodik

Welches System und wie es betrieben wurde

Betriebsbedingungen

5 Läufe extrahiert
LaufT°CpHAnolytpHKatholytSubstrat[S]mg/LHRThModusR_extΩV_appVInokulum
v2-14cd5c7185aa5deb308—CO2——————
v2-519d04a8ad8253ab307.5—CO2——————
v2-88d525f9c8cb04f8307.69—CO2——————
v2-a461a0b50172e023307.57—CO2——————
v2-c86a98801ccaedb530——CO2:H2——————

Extraktionspipeline

Rohextraktionen, Artefakte, Qualitätssignal

Extraktionsqualität

Ehrlichkeitssignal

Bemessen Sie Ihr Vertrauen in die extrahierten Inhalte an diesen Signalen – so hat die Pipeline ihre eigene Ausgabe für diese Publikation bewertet.

Mittlere Parameterkonfidenz

90 %

Durchschnittliche Konfidenz der oben angezeigten PaperParameter-Zeilen

vor dem Zitieren mit dem Quell-PDF abgleichen · Werte 0–1

03

Diagramm-Explorer

Verändern Sie die Eingaben dieser Publikation und sehen Sie, wie sich das vorhergesagte Ergebnis verschiebt.

04

Modell erkunden

Der Reaktor in 3D, mit Strömung, die sich ein- und ausschalten lässt.

05

KI-Erkenntnisse

Widersprüche, Lücken und Chancen aus dem Vergleich dieser Publikation mit dem Korpus.

06

Ähnliche Publikationen vergleichen

Die nächsten Publikationen nach System, Materialien und Organismen, mit ihren Ergebnissen nebeneinander.

07

Quell-PDF

Die Publikation, wie sie erschienen ist.

3D-Modell wird geladen …

Repräsentatives Modell, generisches mikrobielles elektrochemisches System

Repräsentatives Modell: mikrobielles elektrochemisches System – zugeordnet nur anhand des Systemtyps der Publikation, nicht ihres Reaktors oder ihrer Geometrie.

MES
System
19
Extrahierte Werte
2015
Jahr

Schlagwörter

  • Electrosynthesis
  • Chemistry
  • Microbial population biology
  • Environmental chemistry
  • Bacteria
  • Biology
  • Electrode
  • Electrochemistry

Zitieren

Sunil A. Patil, Jan Arends, Inka Vanwonterghem et al. (2015). Selective Enrichment Establishes a Stable Performing Community for Microbial Electrosynthesis of Acetate from CO₂. Environmental Science & Technology. https://doi.org/10.1021/es506149d

Öffnen Sie das Modell im Labor, um alle Steuerelemente, die Parameterbearbeitung und Vorlagen-Overlays zu nutzen.

Im Labor öffnen