Forschungsdaten – Titel und Zusammenfassungen von Publikationen, extrahierte Daten und Katalogeinträge – erscheinen in ihrer Originalsprache Englisch.

Forschung

Publikation · MFC

Novel Porous Nitrogen Doped Graphene/Carbon Black Composites as Efficient Oxygen Reduction Reaction Electrocatalyst for Power Generation in Microbial Fuel Cell

01

Zusammenfassung

Was die Publikation berichtet, in ihren eigenen Worten.

Interaktives 3D-ModellKI-angereichert· 72 %

Zusammenfassung

To improve the power generation of a microbial fuel cell (MFC), a porous nitrogen-doped graphene/carbon black (NG/CB) composite as efficient oxygen reduction reaction (ORR) electrocatalyst was successfully synthesized by pyrolyzing graphene oxide (GO) encapsulated CB with cetyltrimethyl ammonium bromide as a bridge. This concept-to-proof synthesis can be considered as a template-like method. Based on this method, one composite named as NG/CB-10 was acquired using the optimized GO-to-CB mass ratio of 10:1. Electrochemical tests demonstrate that NG/CB-10 can catalyze ORR in neutral-pH medium through a four-electron pathway with positively shifted the onset potential, the enhanced current density and reduced charge transfer resistance. CB addition also prolongs the stability of NG/CB-10. The enhancement in electrochemical performance of NG/CB-10 was attributed to the enlarged surface area, abundant mesopores and high content of pyridinic nitrogen. The maximum power density of MFC equipping NG/CB-10 as cathode electrocatalyst reached 936 mW·m⁻², which was 26% higher than that of NG and equal to that of platinum/carbon. The cost of NG/CB-10 was reduced by 25% compared with that of NG. This work provides a novel method to synthesize promising ORR electrocatalyst for MFC in the future.

KI-Zusammenfassung

72 % Konfidenz

This paper synthesizes nitrogen-doped graphene/carbon black (NG/CB) composites as oxygen reduction reaction (ORR) cathode catalysts for microbial fuel cells. The optimal NG/CB-10 composite (GO:CB mass ratio 10:1) achieved 936 mW·m⁻² power density—26% higher than pristine NG and equivalent to platinum/carbon—while reducing cost by 25%. The composite catalyzes ORR via a four-electron pathway with minimal H₂O₂ production (3.85% yield), enhanced onset potential (0.864 V vs. RHE), and superior stability over one month storage. However, the paper focuses exclusively on cathode ORR performance in neutral-pH PBS and does not address nitrogen cycling, denitrification, nitrification, or ammonia recovery.

Zentrale Erkenntnisse

  • Schwellenwert CB addition shifted ORR onset potential positively from 0.798 V (NG) to 0.864 V (NG/CB-10 at 10:1 GO:CB ratio), a 66 mV improvement that enhanced kinetics (j₀ increased 168% to 2.85 × 10⁻² mA·cm⁻²).

    Was heißt das. Operators should target a GO:CB mass ratio near 10:1 to maximize cathode kinetics; ratios below 5:1 or above 20:1 degrade performance.

  • Mechanismus Charge transfer resistance (Rct) decreased 52.1% from 226.7 Ω·cm² (NG) to 108.7 Ω·cm² (NG/CB-10), indicating faster electron transfer and reduced ORR intermediate accumulation.

    Was heißt das. Lower Rct directly enables the 4e⁻ ORR pathway; composite design should prioritize Rct reduction to suppress 2e⁻ H₂O₂ formation.

  • Leistung H₂O₂ yield dropped from 20.73% (pristine NG) to 3.85% (NG/CB-10), and electron transfer number increased from 3.58 to 3.92, confirming shift from mixed 2e⁻/4e⁻ to predominantly 4e⁻ ORR.

    Was heißt das. The composite suppresses parasitic H₂O₂ production; this is critical for MFC longevity since H₂O₂ can degrade membranes and catalysts.

  • Leistung NG/CB-10 retained 95% of disk current (0.82→0.78 mA at 0.2 V vs. RHE) after one-month ambient storage, while pristine NG lost 39% (0.64→0.39 mA), and n remained stable (3.92→3.91 vs. 3.58→3.51).

    Was heißt das. CB prevents graphene restacking; use NG/CB composites for field deployments where catalyst replacement is costly.

  • Mechanismus BET surface area of NG/CB-10 was 376.94 m²·g⁻¹ (12% higher than pristine NG at 336.62 m²·g⁻¹), with 86% mesopore fraction, enabling efficient mass transport while maintaining micropore activity sites.

    Was heißt das. Mesopore-rich composites reduce mass-transport limitations; design cathodes with >80% mesopore content for high current density.

Ansatzpunkte6

Konkrete Lücken in dieser Publikation, jeweils mit einem Experiment, das sie schließen würde.

  • Hoch No evaluation of cathode potential windows or operating ranges for ORR; paper reports only single potentials (0.2 V, 0.6 V) without mapping performance across full discharge curve.

    MFC operators need to know if NG/CB-10 maintains 4e⁻ efficiency and low H₂O₂ across the full polarization curve (OCV to short circuit); only RRDE and half-cell tests at fixed potentials are shown.

    Versuch. Polarization curve with simultaneous anode/cathode potential measurement; quantify H₂O₂ and electron transfer number at 5–6 potentials spanning 0.6 V to −0.2 V vs. Ag/AgCl

  • Hoch No investigation of catholyte pH effects on ORR pathway or H₂O₂ production; all tests at pH 7.0 only.

    MFC catholytes often drift in pH during operation; paper states ORR occurs 'in neutral-pH medium' but does not test pH 6–8 range or acidic/alkaline extremes.

    Versuch. RRDE and half-cell tests at pH 5.5, 6.5, 7.0, 7.5, 8.5; measure onset potential, n, H₂O₂ yield, and Rct as functions of pH

  • Mittel No measurement of current density or power density as a function of applied cathode potential; only OCV-to-10 Ω polarization curve shown without potential-dependent power analysis.

    Operators need to know optimal cathode potential for maximum power; paper reports 936 mW·m⁻² but does not specify at which cathode potential this occurs or how power varies with potential.

    Versuch. Measure power density and cathode potential simultaneously across external resistances 10–10,000 Ω; plot power vs. cathode potential

  • Mittel No testing of NG/CB-10 in real wastewater or with mixed microbial communities; only synthetic acetate medium with aged inoculum.

    Paper uses 1 g·L⁻¹ sodium acetate in PBS; real MFCs operate on complex substrates (glucose, cellulose, wastewater COD) that may alter biofilm composition and cathode fouling.

    Versuch. Operate NG/CB-10 cathode MFC on municipal wastewater or brewery effluent; measure power density, Coulombic efficiency, and cathode surface analysis (SEM, XPS) after 30 days

  • Mittel No measurement of dissolved oxygen concentration or its effect on ORR kinetics; all tests in O₂-saturated solutions.

    Real MFC cathodes experience variable O₂ availability depending on air diffusion layer design and operating conditions; paper does not test ORR performance under O₂-limited conditions.

    Versuch. RRDE and half-cell tests at O₂ saturation levels 0%, 25%, 50%, 75%, 100%; measure current density, onset potential, and H₂O₂ yield

  • Mittel No long-term MFC operation data; only single polarization curves reported, no time-series voltage or power over weeks/months.

    Paper shows 1-month storage stability of catalyst in ambient conditions but not in operating MFC; fouling, biofilm growth, and membrane degradation may reduce performance.

    Versuch. Operate NG/CB-10 MFC continuously for 60–90 days; measure daily power density, Coulombic efficiency, and cathode potential; perform post-mortem SEM and XPS

Erstellt von der MESSAI-Extraktionspipeline · mit dem Quell-PDF abgleichen

02

Extrahierte Werte

Jeder aus der Publikation entnommene Wert mit seiner Quelle, damit sich jede Zahl am Text prüfen lässt.

n = 5 extrahierte Werte

Wählen Sie eine Quellenangabe, um Zitat, Seite und Konfidenz hinter einem Wert zu sehen.

0 von 4 extrahierten Zeilen modellierbar

  • 2 nicht kanonisiert (kein kanonischer Slug)
  • 2 kein SI-Wert
ParameterWertEinheitKonfidenzQuelleModellierbar
Coulombic efficiency5%80 %
llm
Membrane materialCEM—80 %
extrahiert
Ausgeschlossen: kein SI-Wert
Cathode materialelectrocatalyst reached 936 mw·m−2—70 %
extrahiert
Ausgeschlossen: kein SI-Wert
Catalystfor power generation in microbial fuel cell—60 %
extrahiert
Ausgeschlossen: nicht kanonisiert (kein kanonischer Slug)
Electrode materialgraphene—50 %
extrahiert
Ausgeschlossen: nicht kanonisiert (kein kanonischer Slug)

Literatur-Priors

Verteilung

Im Vergleich zur Literatur

Der in der Publikation berichtete Wert (▼) ist auf der Literaturverteilung aus MESS-Parameters eingezeichnet. Werte außerhalb des Bands werden als Ausreißer gekennzeichnet.

Coulombic efficiency5Prozent

Methodik

Welches System und wie es betrieben wurde

Methodik

Methodology

Nitrogen-doped graphene/carbon black composites were synthesized by pyrolyzing GO-encapsulated carbon black (GO:CB mass ratios 1:1 to 20:1) with cyanamide as nitrogen source and CTAB as a soft-template bridge. Electrochemical performance was evaluated via rotating ring-disk electrode (RRDE) tests in O₂-saturated 0.1 M PBS (pH 7.0) to measure ORR onset potential, electron transfer number (n), and H₂O₂ yield. Half-cell tests on air-cathodes and full MFC tests (dual-chamber, 1000 Ω external resistor, 30°C) measured power density and electrode potentials. Physicochemical characterization included SEM, TEM, XRD, Raman, XPS, and BET surface area analysis.

Systemkonfiguration

FeldWert
reactor typeMFC
chamber config2-chamber

Elektrodenspezifikationen

FeldWert
materials["graphene","platinum"]

Leistungskennzahlen

FeldWert
coulombic efficiency5
citation count15

Ergebnisse

Was gemessen wurde und was funktioniert hat

Kernaussagen

Coulombic efficiency

Elektrochemie

5Prozent

Extraktionspipeline

Rohextraktionen, Artefakte, Qualitätssignal

Extraktionsqualität

Ehrlichkeitssignal

Bemessen Sie Ihr Vertrauen in die extrahierten Inhalte an diesen Signalen – so hat die Pipeline ihre eigene Ausgabe für diese Publikation bewertet.

Parametervollständigkeit

50 %

Anteil der erwarteten Parameter, die extrahiert wurden

Datenvollständigkeit

60 %

Gesamtabdeckung der Extraktion über alle Felder

KI-Konfidenz

72 %

Vom Modell selbst angegebene Konfidenz

Mittlere Parameterkonfidenz

68 %

Durchschnittliche Konfidenz der oben angezeigten PaperParameter-Zeilen

vor dem Zitieren mit dem Quell-PDF abgleichen · Werte 0–1

03

Diagramm-Explorer

Verändern Sie die Eingaben dieser Publikation und sehen Sie, wie sich das vorhergesagte Ergebnis verschiebt.

04

Modell erkunden

Der Reaktor in 3D, mit Strömung, die sich ein- und ausschalten lässt.

05

KI-Erkenntnisse

Widersprüche, Lücken und Chancen aus dem Vergleich dieser Publikation mit dem Korpus.

06

Ähnliche Publikationen vergleichen

Die nächsten Publikationen nach System, Materialien und Organismen, mit ihren Ergebnissen nebeneinander.

07

Quell-PDF

Die Publikation, wie sie erschienen ist.

3D-Modell wird geladen …

Repräsentatives Modell, generisches MFC

Repräsentatives Modell: MFC – zugeordnet nur anhand des Systemtyps der Publikation, nicht ihres Reaktors oder ihrer Geometrie.

MFC
System
5,00Prozent
Bestes Ergebnis · Coulomb-Effizienz
bester von 2
5
Extrahierte Werte
2019
Jahr

In diesem Datensatz

Organismen, Parameter und Materialien, die diese Publikation berichtet. Jeder Eintrag verweist auf seine Seite.

Parameter · 1

Schlagwörter

  • Electrocatalyst
  • Graphene
  • Oxygen reduction reaction
  • Carbon black
  • Microbial fuel cell
  • Carbon fibers

Zitieren

Yuan Liu, Zhimei Liu, Hong Liu et al. (2019). Novel Porous Nitrogen Doped Graphene/Carbon Black Composites as Efficient Oxygen Reduction Reaction Electrocatalyst for Power Generation in Microbial Fuel Cell. Nanomaterials. https://doi.org/10.3390/nano9060836

Zeitschrift
Nanomaterials

Öffnen Sie das Modell im Labor, um alle Steuerelemente, die Parameterbearbeitung und Vorlagen-Overlays zu nutzen.

Im Labor öffnen